IZIP ELECTRIC BIKE REVIEW INSTALL

The plastic cover use the small rubber pieces to block the open holes on the bottom of the power box, insert the power box with the prongs into position on the left side of the battery holder. Music securely connect the two wires from the power box to the trike’s wire, harness tuck, the plugs into the power box and reinstall. Also remove the four mounting screws on the bottom of each power box.

This will expose the wires that will plug into the wire harness that goes into the motor. Remove the four screws on the back of the power box with the prongs and take off the plastic cover.

IZIP ELECTRIC BIKE REVIEW INSTALL

Next, we will install the battery carrier Music, put the battery carrier into place on the frame and secure the four bolts when installing the power box you’ll see that one has metal prongs to connect to the battery and the other does not the power box with the Prongs should be installed on the left side of the battery carrier. Now you can increase the tension in the chain by pulling the rear frame away from the rest of the trike, now tighten down the six bolts to lock them together when everything is tightened properly, the chain should only move up and down about a half an inch. This will give you some space to put the chain on the two sprockets Music, pull on the rear frame until the master link clicks into place once the chain is installed. When the chain is under tension, it will lock the master link into place, push the rear frame in as far as it will go. The two ends simply put the master link pieces in each end of the chain and link them together. Leave these bolts loose until the rear chain is installed Music to install the rear chain. You will find that the left side bolt is already installed Music slide the rear frame into place and install the four bolts to secure them together.

Izip electric bike review